RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Using a Multimeter, check the Knock Sensor terminals 1 to 2 for an internal short.
Specified value: infinite (Infinity).
If the specified value was not obtained:
-
Replace the faulty Knock Sensor (KS) 1 (G61) or Knock Sensor (KS) 2 (G66). Refer to Fuel Injection and Ignition Repair Information.
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Refer to Fuel Injection and Ignition Repair Information.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) ( J623). Refer to => [ Engine Control Module 1, Removing and Installing ] See: Computers
and Control Systems/Engine Control Module/Service and Repair/Engine Control Module 1, Removing and Installing.
-
Using a Multimeter, Check the Knock Sensor electrical harness connector to the Motronic Engine Control Module (ECM) (J623) electrical
harness connector T60 for an open circuit.