RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Air Bag: Removal and Replacement
Spiral Spring/Return Spring With Slip Ring
Spiral Spring/Return Spring with Slip Ring
Special tools, testers and auxiliary items required
‹› Vehicle Diagnosis, Testing and Information System ( VAS 5051 A)
Removing
-
Remove the steering column trim. Refer to => [ Steering Column Trim ] See: Body and Frame/Interior Moulding / Trim/Utility Storage
Compartment/Service and Repair.
-
Disconnect connector - 1 -.
-
Carefully release catch - arrows - and pull return spring with slip ring from steering column switches.
Installing
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
-
Ensure all catches and the connection engage cleanly.
‹› Wheels must be in straight-ahead position when removing or installing return spring with slip ring.
‹› Return spring with slip ring is secured as a new part in center position with a cable tie or shear ring.
‹› On vehicles with ESP sensor in return spring with slip ring, ESP sensor must be adapted.