RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Clockspring Assembly / Spiral Cable: Service and Repair
Steering Column Switch Module
Steering Column Switch Module
General Information
The steering column switches, spiral spring and Steering Angle Sensor (G85) are integrated into a single assembly (module) along with the Steering
Column Electronic Systems Control Module (J527).
Before troubleshooting or servicing, technicians must be familiar with the functions and operation specifics of the steering column electronics. Always
read the owner's manual and review applicable system functions.
‹› Additional information:
=> Owner's Manual
=> Self Study Program - Course Number 991103 " 2002 Audi A4 Technical Features"
=> Self Study Program - Course Number 991503 " The 2005 Audi A4"
=> Wiring Diagrams & Component Locations
Spiral Spring
Special tools, testers and auxiliary items required
‹› Special Screwdriver T8 (T40056) or equivalent " Torx - 8"
Removing
CAUTION!
‹› Ensure steering is in straight ahead and centered prior to removing spiral spring.
‹› Position of spiral spring must not be changed once removed.
-
Move steering wheel down and to rear as far as possible; make use of the full range of the steering column adjuster.
CAUTION!
Special safety precautions apply to vehicles equipped with airbags. Heed all WARNINGS pertaining to airbag servicing.
-
Remove airbag and steering wheel.
‹› Due to manufacturing tolerances, it may not be possible to insert Special Screwdriver T8 (T40056) all the way into access hole in switch module.
In these cases, grind down shoulder of screwdriver in areas indicated - arrows -.
-
Use Special Screwdriver T8 (T40056) to remove screws - 4 - and - 5 -.