RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
1
Seat Occupied Recognition Control Module (J706 )
Installing
-
Secure Seat Occupied Recognition Pressure Sensor (G452) - 4 -.
-
Secure Seat Occupied Recognition Control Module ( J706) with bolts - 2 - (Qty. 2) to 2.5 Nm.
-
Connect connector - 6 -.
-
Upholster the seat pan, thereby all cushion clips must be attached and be installed at the original position. Refer to => [ Seat Pan Cover and
Cushion, Standard Seat ] See: Body and Frame/Seats/Service and Repair/Overhaul/Seats - Upholstery, Covers/Front Seat Covers and Cushion, for
electric seat => [ Seat Pan Cover and Cushion, Standard Seat ] See: Body and Frame/Seats/Service and Repair/Overhaul/Seats - Upholstery,
Covers/Front Seat Covers and Cushion, Power Memory Seats.
Further installation is performed in the reverse order of removal. Observe the following when doing so:
-
After installing the passenger seat in the vehicle, the following program must be performed under "Airbag" in Guided Fault Finding.
When installing a new service kit and after every repair on the front passenger seat:
‹› Seat Occupied Recognition Control Module (J706), basic setting
After the seat was installed
-
Switch on the ignition with the battery disconnected.
CAUTION!
No one should be in vehicle when connecting battery.
-
Connect the battery.
‹› If the Airbag Malfunction Indicator Lamp (MIL) ( K75) shows a malfunction after assembly, DTC memory must be checked with Vehicle
Diagnostic, Testing and Information System ( VAS 5051 A), cleared and then rechecked.
2
Bolts
‹› 2.5 Nm
3
Seat Occupied Recognition Control Module (J706 ) Connector
‹› Must not be separated under any circumstances.
4
Seat Occupied Recognition Pressure Sensor (G452 )
5
Pressure Hose
CAUTION!
The pressure hose - 5 - and the Seat Occupied Recognition Mat must not be kinked under any circumstances during repairs.
-
Secure pressure hose at guide clip - 8 - at specified marking.
6
Connector Between Service Kit and Seat Wiring Harness
‹› deleted on the wiring routing modular => [ Modular Wiring Routing Versions ] See: Body and Frame/Seats/Description and Operation/Front
Seats
7
Seat Occupied Recognition Pressure Sensor (G452 ) Connector
‹› Must not be separated under any circumstances.
8
Guide Clip
9
Retaining Bracket