RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Disconnect the safety belt tensioner connector.
-
Remove the outer floor assembly anchorage point - 6 -. Refer to => [ Outer Front Floor Assembly Anchorage Point ] See: Service and
Repair/Removal and Replacement.
-
Unclip the belt webbing guide - 1 -.
-
Pull the belt webbing - 2 - out of the belt webbing guide - 1 -.
-
Remove belt roller - 4 -.
‹› Installing
-
Install the front safety belt in reverse order of removal.
5 - Bolt
‹› Tightening specification 55 Nm.
6 - Outside Floor Assembly Anchorage Point
Disconnecting the Front Belt Webbing Tensioner Connector
-
Remove the securing clip - 4 -.
-
Remove connector - 3 -.