RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Brake Light Switch: Service and Repair
Brake Lamp Switch
‹› Remove the brake light switch in order to adjust.
‹› To ensure a secure fit, the switch may only be installed once.
Removing
-
Disconnect the electrical connector.
-
Turn the brake light switch counterclockwise 45 degrees in order to remove.
Installing
Installation is in the reverse order of removal. Note the following:
-
Pull out the brake light switch plunger as far as it will go - arrow -.
-
Insert the switch with tabs - 1 - and - 2 - in designated retainers in assembly opening.
-
Install the driver side storage compartment.
‹› The brake pedal must not be actuated during installation.
‹› When installing the brake switch, the plunger adjusts itself automatically.
-
Guide the switch through the installation hole, press against the pedal and secure by turning 45 degrees clockwise.