RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Power Distribution Module: Service and Repair
Cabriolet
Vehicle Electrical System Control Module
Removing
-
If control module is replaced, select "Replacement" function for appropriate control module in "Guided Functions" routine Vehicle diagnosis,
testing and information system VAS 5051.
-
Switch off ignition and remove ignition key.
-
Remove driver's storage compartment.
-
Remove nuts - arrows - and remove Vehicle Electrical System Control Module (J519) - item 1 -.
-
Unclip fuse panels - 1 through 3 -.
-
Release securing bracket at connector - item 4 - and remove.
-
Disconnect electrical connectors - 5 - and - 6 -.
Installing
Install in reverse order of removal, observing the following:
-
Install driver's storage compartment.
Tightening Specifications