RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Power Distribution Module: Service and Repair
Except Cabriolet
Vehicle Electrical System Control Module
‹› Should Vehicle Electrical System Control Module ( J519) require replacement, follow replacement procedures as specified using VAS 5051/5052
in mode "Guided Fault Finding".
Removing
CAUTION!
‹› Switch off all electrical consumers.
‹› Switch ignition off and remove ignition key.
-
Where applicable, remove driver's storage compartment.
-
Remove nuts - arrows - and remove Vehicle Electrical System Control Module (J519) - 1 -.
-
Unclip fuse carriers - 1... 3 -.
-
Release retaining clip at connector - 4 - and disconnect connector.
-
Disconnect electrical connections - 5 - and - 6 -.
Installing
Install in reverse order of removal, noting the following: