RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
^
The clutch pedal should be in the normal position (i.e. not pressed down).
-
Guide Clutch Pedal Switch F36 through mounting hole, press against clutch pedal and attach by turning 45 degrees clockwise.
-
Connect connector for Clutch Pedal Switch F36.
-
Install storage compartment on drivers side.
Clutch Pedal Starter Interlock Switch F194, removing and installing
Note:
^
To ensure a secure fit, the Clutch Pedal Starter Interlock Switch F194 must not be installed more than once.
Removing
-
Remove storage compartment on drivers side.
-
Disconnect electrical connector - 3 - on clutch pedal switch for engine start.
-
Press clutch pedal - 1 - all the way down and hold it in this position.
-
At the same time, release Clutch Pedal Starter Interlock Switch F194 - 2 - by turning it 45 degrees in the direction indicated - arrow - and pull it
out of the guide.