RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Installing
-
Pull out operating rod - arrow - all the way before installing clutch pedal switch.
-
When installing Clutch Pedal Starter Interlock Switch F194, press clutch pedal - 1 - all the way down - arrow A -. Hold clutch pedal in this
position.
-
Guide Clutch Pedal Starter Interlock Switch F194 - 2 - through opening in retainer, and at the same time push operating rod against clutch pedal
and secure switch by turning it 45 degrees in the direction indicated - arrow B -.
-
Attach electrical connector - 3 - on clutch pedal switch for engine start.
-
Install storage compartment on drivers side.