RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Complete power steering pump as shown in illustration and install on engine.
1. Power steering pump
2. Seal
3. Driveshaft, when re-installing, lubricate the drive shaft splines and the power steering pump all the way around. Apply grease into the hole on the
end of the shaft on the engine side.
-
Secure all hose connections with hose clamps appropriate to the model.
-
Install engine console and tighten subframe. Refer to => [ Suspension Assembly Overview ] See: Suspension/Service and Repair/Removal and
Replacement/Front Suspension.
-
Install stabilizer bar. Refer to => [ Stabilizer Bar ] See: Suspension/Stabilizer Bar/Service and Repair/Front Suspension.
-
Check power steering fluid level. Refer to => [ Power Steering, Checking Fluid Level ] See: Power Steering Fluid/Testing and Inspection.
-
Bleed steering. Refer to => [ Steering System, Bleeding after Reconstructing ] See: Power Steering Bleeding/Service and Repair.
-
Check steering for leaks. Refer to => [ Steering System, Checking for Leaks ] See: Testing and Inspection/Component Tests and General
Diagnostics/Steering System, Checking for Leaks.
Tightening Specifications