RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
5 - Power steering pump
‹› Fill with hydraulic oil before installing
‹› Checking delivery pressure, refer to => [ Power Steering Pump Delivery Pressure, Checking ] See: Testing and Inspection/Component Tests
and General Diagnostics/Power Steering Pump Delivery Pressure, Checking
6 - Bolt
‹› 65 Nm
7 - O-Ring
8 - Sleeve
‹› Lubricate the splines all around with grease.
9 - Input Shaft
‹› Lubricate the splines all around with grease.
10 - Spring
‹› Coat lightly with grease before inserting in the input shaft
11 - Buffer stop
12 - Bolt
‹› 25 Nm
13 - Heat shield
‹› Installed depending on the engine version
14 - Bolt
‹› 9 Nm
15 - Clamp
‹› Tension using Hose Clamp Pliers (V.A.G 1275)
‹› Always replace
16 - Intake hose
‹› Note the installation position
‹› Markings must align
‹› The lines - magnified area of the illustration - are shown without spring clips