RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Steering Gear: Removal and Replacement
Servotronic Steering Gear Assembly Overview
Servotronic Steering Gear Assembly Overview
1
Power assisted steering gear with tie rods
‹› Assembly overview, refer to => [ Power-Assisted Steering Gear Assembly Overview ] See: Power-Assisted Steering Gear Assembly Overview
2
Servotronic Solenoid Valve (N119) connector
‹› Component location: In left front wheel housing
3
Relay carrier, 9-pin
‹› Located under trim in driver's footwell,
‹› Servotronic Control Module (J236), item 2
‹› Check voltage supply, refer to => [ Voltage Supply for Servotronic, Checking ] See: Testing and Inspection/Component Tests and General
Diagnostics/Voltage Supply for Servotronic, Checking
‹› Checking speed signal, refer to => [ Speed Signal, Checking ] See: Testing and Inspection/Component Tests and General Diagnostics/Speed
Signal, Checking
4
Servotronic Solenoid Valve (N119) with fused connector cable
‹› Remove steering gear to replace Servotronic Solenoid Valve