RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Tightening of the respective bolts/nuts must then only occur after dimension - a -, which was measured before installation between the wheel hub
center and the lower edge of wheel housing, has been attained
CAUTION!
‹› Do not lift or lower vehicle with engine/transmission jack below vehicle.
‹› Do not leave Engine/Transmission Jack (V.A.G 1383 A) below vehicle any longer than necessary.
-
Tighten respective bolts/nuts.
-
Lower wheel bearing housing.
-
Move engine and Engine/Transmission Jack (V.A.G 1383 A) away from under vehicle.
-
Remove Wheel Hub Support (T10149).