RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Install cap bolts - 1 - and tighten
-
Install outer drive axle joint into hub and hand tighten with a new hex bolt.
^
Remove any adhesive residue on joint pin threads.
-
Insert both upper link joint pins in wheel bearing housing and bend downward as much as possible using assembly tool T40067.
-
Insert new bolt - 1 - and self-locking nut and tighten
-
Install ABS speed sensor.
-
Install brake disc, fasten brake caliper.
-
Mount wheel and tighten. This information is contained in AESIS; Library; Additional Information; Wheels and Tire Guide
-
Tighten drive shaft hex screw (only with vehicle resting on wheels - risk of accident -).
Alignment must take place on a VW/Audi recommended alignment stand.