RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Secure support pieces at left of transmission as shown in illustration. Tighten M10x20 bolt - right arrow - to 20 Nm.
-
Secure support pieces at right of transmission as shown in illustration. Tighten M10x20 bolt - left arrow - to 20 Nm.
-
Remove last 2 engine/transmission bolts.
-
Press transmission out of alignment sleeves and carefully lower with Engine/Transmission Jack (V.A.G 1383 A) until clutch slave cylinder is
accessible.
‹› When lowering the transmission, make sure the hydraulic line to the clutch slave cylinder is not damaged.
-
Remove clutch slave cylinder - arrow - and tie up with wire, do not open line system.