RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Disconnect connector on the Clutch Pedal Switch ( F 36) - 1 -, Brake Lamp Switch - 2 - and on the accelerator pedal module - 3 -.
-
If equipped, disconnect connector from Clutch Pedal Starter Interlock Switch (F194).
-
Remove mounting bracket bolt - arrow B - and remove entire pedal assembly.
Release clutch master cylinder actuator rod from clutch pedal as follows:
‹› When releasing, make sure clutch pedal does not run into clutch pedal switch mount - arrow -. The mount could break off.
‹› To ensure sufficient secure seating for Clutch Pedal Switch (F 36) => [ (Item 6) ] See: Clutch Pedal Assembly/Service and Repair/Removal and
Replacement/0A3A Transmission/Pedal Assembly Overview and Clutch Pedal Starter Interlock Switch (F 194 ) => [ (Item 14) ] See: Clutch Pedal
Assembly/Service and Repair/Removal and Replacement/0A3A Transmission/Pedal Assembly Overview, these switches must only be installed
once.
-
Place Spark Plug Pliers (V.A.G 1922) in clutch pedal recesses, press mount => [ (Item 9) Base block ] See: Service and Repair/Removal and
Replacement together and disconnect clutch pedal from clutch master cylinder.
-
Remove securing clamps - 1 - and clutch pedal - 2 -.