RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Clutch Release Bearing: Service and Repair
Clutch Release Mechanism Assembly Overview
Clutch Release Mechanism Assembly Overview
1
Clutch slave cylinder
‹› Removing and installing on vehicles with 8-cylinder engine, refer to => [ Clutch Slave Cylinder, on Vehicles with 8-Cylinder Engine ] See:
Clutch Hydraulic System/Clutch Slave Cylinder/Service and Repair/0A3A Transmission
‹› Do not operate clutch pedal after removal
‹› Observe work sequence when bleeding, refer to => [ Clutch System, Bleeding ] See: Clutch Hydraulic System/Service and
Repair/Procedures/0A3, 6-Speed All Wheel Drive M/T
‹› Tighten bleeder valve to 4.5 Nm.
‹› When inserting, push in so far until the bolt can be installed.
2
Internal hex bolt, 23 Nm
‹› Clutch slave cylinder on transmission
‹› Self-locking
‹› Replace
3
Bracket