RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-1453001.png)
Pressure Plate: Specifications
6 SPD. M/T 0A3 AWD
SAC pressure plate (LuK version) - 6 Spd. Manual Transmission 0A3 All Wheel Drive
5 - SAC pressure plate
6 - Bolt ..................................................................................................................................................................................................................... 22 Nm
Screw in all 6 bolts evenly by hand until bolt heads make contact with pressure plate.
Tighten all six bolts consecutively in clockwise direction and in steps of 90 degrees (1/4 turn) until the housing makes contact with flywheel.
Tighten all 6 bolts to final torque consecutively in clockwise direction.
When installing a new clutch plate in conjunction with a used SAC pressure plate, the adjuster ring in the pressure plate has to be reset by turning it
back as far as it will go. If you do not reset the adjuster ring in the pressure plate, the SAC pressure plate will operate with reduced clamping force,
which will cause excessive wear, especially of the clutch plate (clutch will then slip).
