RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-1552002.png)
-
Check for a factory marking (colored dot) on driveshaft and on driveshaft flange on final drive at the rear. If no colored dot is present, mark the
position of the driveshaft flange - arrow A - relative to the rear final drive - arrow B - with a colored dot.
-
Engage Assembly tool (3139) and tighten plastic nuts.
‹› Never install assembly appliance onto balance plates.
-
Remove bolts - arrows - for the center bearing.
