RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-1513002.png)
1 - Cover
^
Carefully drive off using a drift
^
Always replace
^
Coat sealing surface with D 454 300 A2 before installing on constant velocity joint
^
Align cover to screw holes
2 - Circlip
^
Remove and install with commercially-available circlip pliers
^
Always replace
3 - Inner CV joint with protective boot cap
^
Exterior diameter: 108 mm
^
Replace only as a unit
^
Pressing off
^
Pressing on
^
Greasing
^
Adhesive surface must be free of oil and grease
^
When installing joint on profile shaft, profile shaft splines must be lightly coated with grease used in joint.
4 - Backing plate
5 - Multi-point socket head bolt
^
Torque specifications:
Screw M 8: 40 Nm
Screw M10: 65 Nm
6 - Clamp
^
Always replace
^
Tensioning
7 - Protective boot for inner constant velocity joint
^
With vent hole
^
Check for tears and chafing; replace if necessary
^
In case of damage, check inner constant velocity joint
^
Protective boot/drive axle/cap sealing surfaces must be free of grease at installation
8 - Axle shaft
9 - Outer constant velocity protective joint boot
^
Exterior diameter: 88 mm
^
Without ventilation bore
^
Check for tears and chafing; replace if necessary
^
In case of damage, check outer constant velocity joint Outer constant velocity (CV) joint, checking
^
Protective boot/drive axle/joint sealing surfaces must be free of grease at installation
10 - Clamp
^
Always replace