RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
2 - Outer constant velocity joint
‹› Replace only as complete unit
‹› Removing => [ Outer CV joint, removing ] See: Outer Constant Velocity Joint, 100 mm, Replacing
‹› Installing => [ Outer CV joint, installing ] See: Outer Constant Velocity Joint, 100 mm, Replacing
‹› Greasing
‹› Checking, refer to => [ Outer Constant Velocity Joint, 100 mm, Checking ] See: Testing and Inspection/Front Suspension/Outer Constant
Velocity Joint, 100 mm, Checking
‹› When installing joint on axle shaft, splines on axle shaft must be lightly coated with grease used in joint.
3 - Securing ring
‹› Always replace
‹› Insert before mounting in ring groove (not visible with joint installed)
4 - Clamp
‹› Always replace
5 - CV boot for outer constant velocity (CV) joint
‹› Check for tears and chafing, replace if necessary
‹› In case of damage, check outer CV joint, refer to => [ Outer Constant Velocity Joint, 100 mm, Checking ] See: Testing and Inspection/Front
Suspension/Outer Constant Velocity Joint, 100 mm, Checking
‹› Before clamping hose clamps, raise protective joint boot briefly to balance pressure.
‹› Sealing surfaces must be free of grease when installing.
6 - Drive axle
7 - Cover
‹› Always replace
8 - Gasket
‹› Always replace
9 - Securing ring
‹› Always replace
‹› Insert in shaft groove
10 - Inner constant velocity joint
‹› Exterior diameter: 100 mm
‹› Replace only as complete unit
‹› Removing => [ Inner CV joint, removing ] See: Inner Constant Velocity Joint, 100 mm, ServicingCV
‹› Installing => [ Inner CV joint, installing ] See: Inner Constant Velocity Joint, 100 mm, ServicingCV
‹› Greasing
‹› Adhesive surface must be free of oil and grease