RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
*
Using shim tolerances it is possible to find the exact shim thickness required, insert two shims if necessary.
-
Place determined shim "S4" (0.85 mm in example) and retaining plate - A - (only fits in one position) on transmission housing bolting surface.
-
Then tighten screws - arrows - diagonally to 30 Nm.
Performing measuring check, checking dimension " E"
-
Install drive pinion with measured adjustment shims "S 3" and "S4".
-
Install universal mandrel and perform measurement check.