RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Clamp flange shaft in vise, using jaw protectors. Press circlip with new circlip - A - out of flanged shaft groove.
-
Lightly oil new seal on outer circumference.
-
Drive in new drive flange seal 5.65 ± 0.15 mm below transmission housing, without canting.
-
Fill area between sealing lip and dust lip halfway with Sealing Grease (G 052 128 A1).
-
Drive in flange shaft using Centering Mandrel ( VW 295).
-
Install the drive axle heat shield.
-
Drive axles, installing on flange shafts => Steering and Suspension See: Steering and Suspension
-
Check gear oil level in manual transmission and fill => [ Manual Transmission, Checking Gear Oil Level ] See: Fluid - M/T/Service and
Repair/0A3A Transmission.
-
Install noise insulation.