RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Align gear lever so that it points slightly (1.5 degrees) to the right (as seen in direction of travel).
-
Hold gear lever in this position.
-
Tighten bolt for selector rod - arrow - to 23 Nm.
Note:
^
The gear lever must remain in the same position while the bolt is being tightened.
Checking gear lever setting
^
The gear lever should rest in the 3rd/4th gear gate when the transmission is in neutral.
-
Press clutch pedal.
-
Select all gears several times.
-
Check operation of reverse gear lock.
^
It should only be possible to engage reverse gear after pressing the gear lever down to overcome the reverse gear lock.
^
The gear lever should return by itself from the reverse gear gate to the 3rd / 4th gear gate.
If the gear lever sticks or balks repeatedly when engaging a gear, perform the adjustment procedure again.
-
Install trim parts and gear lever knob.