RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Drive securing bushing into transmission to stop with Slide Hammer (VW 771).
‹› Do not tilt securing bushings when driving in.
‹› Installation of securing bushing - arrow B - is carried out in the same way.
-
If equipped, tighten clutch wiring bracket - 2 - together with connecting rod - arrow -. Tightening specification => [ (Item 7) Bolt, 20 Nm ] See:
Selector Rod, Connecting Rod and Push Rod Assembly Overview.
-
Connect electrical connector - 1 - at Back-Up Light Switch (F4).
-
Install noise insulation.