RS 4 Quattro Sedan V8-4.2L (BNS) (2007)
Exhaust Pipe: Service and Repair
Right Front Exhaust Pipe With Primary And Main Catalytic Converter, Removing And Installing
Special tools, testers and auxiliary items required
-
Engine/transmission jack V.A.G 1383 A
Removing
NOTE:
-
During installation, re-install all heat insulation sleeves and heat shields at the same locations.
-
All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.
NOTE: Flex joint in exhaust pipe must not be bent more than 10 degrees, otherwise it may be damaged.
-
Disconnect exhaust system at clamping sleeves - 1 - and - 2 - .
-
Place plunger of engine/transmission jack V.A.G 1383 A with a block of wood inserted in between - arrow - beneath rear cross member.
-
First remove bolts - 1 - and - 2 - , then bolts - 3 - and - 4 - .