RS 6 V8-4.2L Turbo (BCY) (2003)
![background image](/audi/rs_6/v8-4.2l_turbo_(bcy)/Page-1404002.png)
-
Cut off nozzle of tube at front marking (nozzle diameter approximately 1 mm).
-
Place new gasket -1- on cylinder block.
-
Apply a thin bead of silicone sealant at joints between cylinder block and upper section of sump on each side (arrows).
-
Apply a thin coat of silicone sealant to lower sealing surface of sealing flange -hatched area-.
Note: Sealing flange must be installed within 5 minutes after applying silicone sealant.
-
When installing, slide assembly sleeve from installation kit onto crankshaft.
-
Push sealing flange carefully onto dowel pins in cylinder block.
-
Tighten bolts securing rear sealing flange.
-
Install drive plate.
-
Install engine.
Tightening torques