RS 6 V8-4.2L Turbo (BCY) (2003)
Ignition Switch Lock Cylinder: Service and Repair
Lock Cylinder, Removing and Installing
Lock Cylinder, Removing and Installing
Removing
-
Remove steering column switch.
-
Disconnect harness connector for induction coil -4-.
Vehicles with automatic transmission
-
Place selector lever in position "P".
-
Switch ignition key in position -B- to "Ignition ON".
-
Then lift locking bracket -1- slightly and pull locking cable -2- from ignition lock housing.
All:
NOTE: The spare key is necessary for removing the lock cylinder, because the following sequence can only be performed using an ignition key with flat
key grip, i.e. without illumination and without remote control.
-
Insert spare key into ignition lock and turn to position "Ignition ON", this will reveal the opening/hole in front of the lock next to the ignition key
slot.