S4 V8-4.2L (BHF) (2004)
-
Dimension - a - = 8.5 mm.
-
Dimension - b - = 15.5 mm.
Adhering centering pins on side impact molding
NOTE: Adhesive and centering pin are in delivery casing of side impact molding.
-
Remove protective foil from the double-sided adhesive - 3 - and adhere it onto centering pin - 4 -.
-
Remove second protective foil and position centering pin onto marking - arrow - on side impact molding.
-
Remove protective foils from double-sided adhesive strips - 2 - and press side impact molding - 1 - onto bumper.
Positioning license plate mounting holes
There are four centering punch marks on license plate area of bumper cover which must be drilled through for securing a license plate (dimensions
115 x 520 mm).
If centering punch marks are not visible, proceed as follows:
-
Determine vertical bisecting line from Audi emblem to center of grill on bumper.
-
Determine horizontal bisecting line:
-
Dimension - a - = dimension - a -.
-
Determine mounting points for license plate symmetrically as follows:
-
Dimension - x - = 139 mm
-
Dimension - y - = 62 mm