S4 V8-4.2L (BHF) (2004)
Front Door Window Motor: Service and Repair
Motor For Window Regulator, Removing And Installing
Removing
-
Door trim removed.
NOTE:
-
Motor for window regulator can be removed or installed in every position of motor or side window.
-
Before removing motor, disconnect electrical harness connectors.
-
Remove Torx bolts - 2 - T30 and remove motor.
Installing
-
When installing, make sure that threaded pins - arrows - are engaged in inner door plate.
-
Slide on window regulator motor - 1 - and secure with bolts - 2 -.
-
Tightening torque 3.5 Nm
NOTE:
-
Only switch ignition on and off after installing motor and connected wires.
-
Then move door window upward to stop and keep pressing switch for window regulator for approx. 2 seconds longer.
-
This position is the base position and the high-and low-running function is activated.