S4 V8-4.2L (BHF) (2004)
Rear Door Window Regulator: Service and Repair
Window Frame and Window Regulator
Window Frame And Window Regulator, Removing And Installing
1
-
Window frame
-
Removing:
-
Remove door trim. Body Interior.
-
Remove window regulator motor or manual window regulator.
-
Disconnect electrical harness connectors.
-
Remove bolts - 7 - and - 8 -.
-
Remove bolts - 3 - - 4 - ;- 6 - and - 10 - and lift window frame with window regulator upward and out of door.
-
Installation:
-
Insert window frame and window regulator into door from above.
-
Knock in the upper profile halves of door-side gasket into window frame at top.
-
Loosely screw in mounting bolts - 4 - at front and rear.
-
Then, loosely screw in bolts in the sequence - 3 - ;- 10 - ;- 8 -.
-
Tighten collared shoulder bolts - 4 - hand tight.
-
Lightly press window frame - 1 - inward at top.
-
Tighten bolts - 3 - and - 10 - to 32 Nm.
-
Tighten collared shoulder bolts - 4 - to 32 Nm.
-
Tighten bolt - 8 - to 10 Nm.
-
Tighten locating bolt - arrows - in window frame to 32 Nm.
-
Knock in lower half of door seal into inner door plate.
-
Secure window regulator rail with bolt - 7 - to inner door plate.
-
Press threaded pin of window regulator reel through inner door plate until it engages.