S4 V8-4.2L (BHF) (2004)
Headliner: Service and Repair
Headliner, Removing and Installing (Sedan)
Headliner, Removing And Installing
1
-
Headliner
-
Removal:
-
Remove right and left sun visor.
-
Remove sun visor center holder - 7 -.
-
Unclip cover cap - 8 -.
-
Remove two clips and disengage expanding clip underneath.
-
Remove visor center bracket.
-
Remove upper left and right A-pillar trim.
-
Remove upper B-pillar trim.
-
Remove roof end strip.
-
Remove D-pillar trim on left and right.
-
Remove rear interior reading light - 6 -.
-
If present, open sunroof.
-
Remove slide/tilt sunroof cover frame - 2 -.
-
Remove left and right lighting for make-up mirror.
-
Remove front interior reading light - 5 -.
-
Unclip cover on rearview mirror boot and disconnect electrical harness connector to rearview mirror.
-
Place shifter or selector lever in front position.
-
Position passenger seat backrest as far back as possible.
-
Position drivers seat backrest as far back as possible.
A second technician is needed to support the molded headliner.
-
Loosen rear clip - 3 - on molded headliner.
-
For vehicles with sunroof, remove front bolt - 4 - on molded headliner.
-
To remove cable on molded headliner, exit vehicle and carefully lower headliner onto seat.
-
If necessary, disconnect wiring harness from A-pillar.
-
Disconnect wiring harness from molded headliner.
-
Remove molded headliner through a rear door.