S4 V8-4.2L (BHF) (2004)
-
Fold seat fully toward front.
-
Remove height adjuster gearing.
-
Remove both microencapsulated bolts - 1 - at sail to height adjuster gearing.
-
Clean threaded holes on height adjuster gearing.
-
Secure new height adjuster gearing to sail using both new microencapsulated bolts - 1 -
NOTE: Threaded holes for screws must always be cleaned (for example, with thread cutter).
-
If damaged, replace white plastic toothed segment.
-
Carefully insert height adjuster gearing and make sure white plastic toothed segment is not damaged.
-
Guide shoulder pin through height adjuster gearing, sail and drive lever and tighten new nut.
-
Clean threaded holes in seat rail.
-
Fold seat fully toward rear.
-
Secure seat to seat rail using microencapsulated bolts supplied.
NOTE: Threaded holes for screws must always be cleaned (for example, with thread cutter).