S4 V8-4.2L (BHF) (2004)
-
Cut tube nozzle at front marking (nozzle approximately 1 mm diameter).
-
Apply sealant bead - arrows - on clean sealing surface of lower section of oil pan as shown in illustration.
^
Thickness of sealant bead: 1.5 to 2.0 mm
Note:
^
Observe the position of the sealant bead at areas indicated with - arrows -.
^
The oil pan (lower part) must be installed within 5 minutes after application of sealant.
^
Sealant bead must not be thicker than specified, otherwise excess sealant may get into lower section of oil pan and clog strainer in intake tube.
-
Install oil pan (lower part) and pre-tighten all bolts diagonally to 5 Nm.
-
Tighten bolts of lower section of oil pan in diagonal sequence to 10 Nm.
The rest of the installation is performed in reverse order of removal. Note the following:
-
Install stabilizer.
-
Install front coolant pipe
-
Install lock carrier with attachments. See: Body and Frame/Lock Carrier/Service and Repair/Procedures
-
Place torque support on rubber buffer for torque support and tighten bolts - arrows -.
-
Install front bumper cover.
-
Add engine oil and check oil level
-
Fill with coolant.
-
Check headlight adjustment.
Tightening torques