S4 V8-4.2L (BHF) (2004)
-
Screw crankshaft holder 3242 into hole (20 Nm). If necessary rotate crankshaft very slightly back and forth to completely center holder.
-
Pre-tighten camshaft bolt - 1 - on exhaust camshaft of left cylinder head.
^
Tightening torque: 40 Nm.
-
Secure camshaft position sensor wheel on camshaft adjuster of intake camshaft of left cylinder head using setting gauge T40047.
-
Place setting gauge T40047 on bolt - 1 -.
-
Pre-tighten camshaft bolt - 2 - on intake camshaft.
^
Tightening torque: 40 Nm.
-
Secure camshaft position sensor wheel on camshaft adjuster of intake camshaft of right cylinder head using setting gauge T40047.
-
Place setting gauge T40047 on bolt - 2 -.
-
Pre-tighten camshaft bolt - 1 - on intake camshaft.
^
Tightening torque: 40 Nm.
-
Remove setting gauge T40047.