S4 V8-4.2L (BHF) (2004)
-
Slide drive axle outer joint into wheel hub and tighten new hex bolt hand-tight.
-
Insert track control link joint pins and guide link into wheel bearing housing.
-
Install and tighten new self-locking nuts; counterhold joint pin if necessary with 4 mm Allen key.
-
Install both upper links joint pins in wheel bearing housing and press down as far as possible by clamping with special tool T40067.
-
Install and tighten new bolt - 1 - and self-locking nut.
Note:
^
The tie rod/ball joint must be inserted into the steering arm - 1 - by hand. Make sure that no force is applied to seal - 2 -.
-
Insert tie rod.
-
Install and tighten new self-locking nut - 4 -.