S4 V8-4.2L (BHF) (2004)
-
Use screwdriver to pry off retaining strap - arrows -.
-
Lay aside engine control module with wires attached.
-
Release retaining clip for transmission control module.
-
Lay aside transmission control module with wires attached.
-
Disconnect electrical connections at rear of connector console.
Vehicles through 10.04:
-
Remove electrical wire - 2 -.
-
Remove screws - 1 - and - 3 -.
-
Unclip appropriate socket.
NOTE: Refer to the applicable wiring diagram for exact identification of connections on connector station Wiring Diagrams