S4 V8-4.2L (BHF) (2004)
/Page-2947002.png)
-
Crimp connector must be heated working outwards from center until it is completely sealed and adhesive emerges.
-
Set the hot air blower to the correct temperature; refer to operating manual for VAS 1978.
-
When shrink-fitting, ensure no other wires, plastic components or insulating materials are damaged by the hot nozzle.
-
If repair wire was previously wrapped, yellow insulating tape must again be wound around this point; reattach wire with a cable tie if necessary.
-
Reconnect battery.
