S4 V8-4.2L (BHF) (2004)
-
Check the following wire connections for open circuit according to wiring diagram.
Harness connector
Test box Socket
Terminal
1
72
2
73
3
36
4
35
5
33
6
34
Specified value: Wire resistance max 1.5 Ohms
-
Check wires for short circuit to each other, to B+ and Ground (GND).
-
Specified value: Infinite Ohms (no continuity)
-
If necessary, repair wire connection.
If no malfunction is detected in the wiring and if the voltage supply was OK:
-
Replace accelerator pedal module
Assembly is performed in reverse order of removal, note the following:
-
Install left knee bolster.
Final procedures
After repair work, the following work steps must be performed in the mentioned sequence:
1. Check DTC memory see "Mode 3: Check DTC memory". See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Mode 3: Check DTC Memory
2. If necessary, erase DTC memory see "Mode 4: Reset/erase diagnostic data". See: Computers and Control Systems/Testing and Inspection/Scan
Tool Testing and Procedures/Mode 4: Reset/Erase Diagnostic Data
3. Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness
Codes/Readiness Code, Generating
-
End diagnosis and switch ignition off.