S4 V8-4.2L (BHF) (2004)
1. Airbag Control Module
-
Removing:
-
Disconnect battery Ground (GND) strap.
-
Remove center console.
-
Disconnect securing bracket - 4 - at connector - 3 -.
-
Disconnect connector - 3 - from control module -1 -.
-
Remove bolts - 2 - (3x).
-
Remove control module.
-
Installation:
Installation is performed in the reverse order of removal.
NOTE:
-
Observe safety precautions after connecting battery.
-
If Airbag Malfunction Indicator Lamp (MIL) K75 signals a malfunction after installation, DTC memory must be checked, erased and once
again checked using Diagnostic Operating System VAS 5051 A.
-
After replacing control module, it must be coded.
2. Screws (3x)
-
Tightening torque 7 Nm
3. Connector
4. Securing clip