S4 V8-4.2L (BHF) (2004)
-
Remove rear engine cover (arrows).
-
Disconnect connector at oil pressure switch (arrow).
-
Remove oil pressure switch.
-
Connect oil pressure tester V.A.G 1342 with adapter 1342/14 to hole for oil pressure switch.
-
Screw oil pressure switch -2- into V.A.G 1342.
Checking oil pressure switch
-
Connect brown wire -1- of tester to earth (-).
-
Connect voltage tester V.A.G 1527B with test leads from V.A.G 1594A to oil pressure switch and battery positive (+).
-
LED must not light
-
If LED lights, replace oil pressure switch.
-
Start engine.
Note: Observe tester and LED on starting, as switching point of oil pressure switch may already be exceeded when starting.
-
LED must light at 1.2 ... 1.6 bar
-
If LED does not light, replace oil pressure switch.
Checking oil pressure
-
Start engine (engine oil temperature approximately
^
Oil pressure at 2000 rpm: min. 2.0 bar
^
Oil pressure at 3500 rpm: min. 3.5 bar
^
Oil pressure at higher engine speed: max. 4.0 bar
If readings do not match specifications: