S4 V8-4.2L (BHF) (2004)
-
After installing, check electrical connection of metal ring at fuel filler tube to a bare area of chassis using Ohm meter - Specified value: approx.
0 ohm.
14. Ventilation line
15. Ventilation line
-
From gravity valve to EVAP canister
-
To remove, press release ring on EVAP canister
16. Ventilation line
-
From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
-
To remove, press release ring on EVAP canister
-
Clipped in on fuel tank
17. Fuel tank
18. Spreader clip
19. 23 Nm
20. Securing strap
21. Heat shield
-
For fuel tank
22. 2 Nm
23. 23 Nm
Installation position of Ground (GND) connection
-
Route Ground (GND) connection as shown in figure.
-
First hook Ground (GND) connection contact - 1 - into securing hole on fuel tank - 5. and then press in spacer bushing - 2
-
Make sure connector of Ground (GND) connection - 4. fits securely at metal ring - 3 - of fuel filler tube.
CAUTION: After installing, check electrical connection of metal ring at fuel filler tube to a blank portion of chassis using Ohm meter.
Specification: approx. 0 Ohm.