S4 V8-4.2L (BHF) (2004)
Vehicles with automatic transmission:
-
Remove heat shield - 1 - for drive shaft (right-side).
-
Remove earth cable -1-.
-
Remove nut at starter solenoid terminal B+ - 3 - and connection for terminal 50 -4-.
-
Remove bolts - 2 - and - 5 -.
-
Remove starter.
Installing
Install in reverse order of removal, noting the following:
-
Install engine mounting and tighten subframe.
-
Install anti-roll bar.
-
Reconnect battery. Required steps.
Tightening torques
Component - fastener
Nm
tarter to transmission - bolt
65
Terminal B+ to starter - nut
16
Ground cable to starter - bolt
22
Engine support to cylinder block - bolt
42 *
Drive shaft heat shield to transmission - bolt
23
* Install using locking fluid.