S4 V8-4.2L (BHF) (2004)
Shift Cable: Service and Repair
Selector Lever Cable, Removing and Installing
Selector lever cable, removing and installing (vehicles with 4.2 ltr. MPI engine), 09L, 6 Spd. A/T AWD
Special tools, testers and auxiliary items required
Engine/transmission jack V.A.G 1383 A
Removing
-
Shift selector lever to position "P".
Note:
^
To prevent damage, the flexible couplings in the front exhaust pipes must not be bent further than 10°.
-
Disconnect exhaust system at clamps - arrows -.
-
Disengage rear section of exhaust system at rubber mountings and remove.
Note:
^
A second technician is required for removing the rear section of the exhaust system.
-
Remove heat shield - A - for driveshaft - arrows -.