S4 V8-4.2L (BHF) (2004)
-
Screw in securing bolt - 1 - for brake fluid reservoir and Connect connector at brake fluid level warning contact.
-
Tighten hexagon socket head bolt - arrowB - for securing pedal cluster to instrument panel carrier to 25 Nm.
-
Connect connectors - 1 -, - 2 - and - 3 -.
-
If installed, attach connector for Clutch Pedal Starter Interlock Switch F194.
-
Connect brake pedal to brake servo.
-
Secure steering column to steering box - arrowA -.
-
Install over-center spring.
-
Install storage compartment on drivers side.
-
Bleed clutch system.
-
Install electronics box and tighten nuts -arrows- to 4 Nm.
-
Route engine wiring harness and Connect connector in connector console.
-
Install engine control module.
-
If applicable, install auxiliary relay carrier and auxiliary fuse carrier.
-
Press on cover (hand-tight) and tighten bolts in diagonal sequence to 4 Nm.
-
Follow steps required after connecting battery.
Note:
^
Upon re-connecting the battery, remember to check and activate the vehicle equipment (radio, clock, convenience electrics etc.).