S4 V8-4.2L (BHF) (2004)
^
For the following procedures, make sure that the clutch pedal does not press out switch - 1 - from securing clip, since the thread of the switch
would be damaged and the switch would have to be replaced.
^
To ensure proper securing, the switch may only be installed once.
-
Remove bolts for master cylinder (arrow - 2 -) and for mounting bracket (arrow - 3 -).
-
Pull complete pedal assembly somewhat toward seating compartment and remove clutch master cylinder - 4 -.
Installing
Installation is the reverse order of removal, while noting the following:
-
Insert master cylinder so that the so that seal - 1 - with washer sits behind bearing mount and tighten bolts - 2 - to 20 Nm.
-
Press connecting line - 3 - with guide - arrow A - into groove - arrow B - at mounting bracket.
A second technician is necessary for the next work step.