S4 V8-4.2L (BHF) (2004)
/Page-2361006.png)
-
Always replace seal - C -.
-
Make sure seal does not cover chassis opening and elevated edge of sheet metal.
-
Insert E-Box in securing point - B - and tighten nuts - A - to 4 Nm.
-
Press cover on by hand and tighten bolts - A - diagonally to 4 Nm (also see inscription on cover).
-
Install engine wiring harness and connect harness connector in connector station.
-
Install engine control module and if necessary, auxiliary relay carrier and auxiliary fuse holder.