S4 V8-4.2L (BHF) (2004)
1 - Wheel bearing housing
^
Removing and installing
2 - Wheel bearing
3 - Wheel hub
^
Removing and installing
4 - Collared bolt
^
Always replace
^
Tighten to 200 Nm plus an additional 180° 1/2 turn
^
Tighten to 200 Nm while vehicle is raised; turn through specified angle only when vehicle is standing on its wheels
^
Do not loosen more than 90° when vehicle is standing on its wheels
5 - Drive axle
^
Removing and installing
^
Servicing (with 100 mm diameter inner joint)
^
Servicing (with 108 mm diameter inner joint)
6 - Washer
7 - Self-locking nut
^
Always replace
8 - Shock absorber
^
Removing and installing
^
Note correct installation position
^
Note different suspension versions; see vehicle data sticker
^
Faulty shock absorbers must always be degassed and drained before disposal
^
Checking shock absorber following removal
9 - Combi bolt, 36 Nm
10 - Hex socket head bolt, 10 Nm
11 - Speed sensor
^
Routing of wiring