S4 V8-4.2L (BHF) (2004)
-
Remove securing bolt for flange shaft, then screw two bolts into the flange and counterhold the flange shaft using the assembly lever.
-
Pull out flange shaft.
-
Pry out flange shaft oil seals using a suitable lever.
Installing
Installation is carried out in reverse order. Note the following:
-
Pack space between sealing and dust lips half-full with sealing grease G 052 128 A1.
-
Lightly oil outer circumference of seal.
-
Drive new seal in onto stop, for this purpose do not cant seal.
-
Insert flange shaft.
-
Fasten flange shaft with cone head bolt.
-
Top off gear oil in rear final drive and check oil level.
-
Attach drive axles.